East Coast Supercharging Lysholm 2010+ Camaro Supercharger Kit - Manual (Page 38)

P/N: 4LGE020-010 v1.1, 2011-04-29
© 2011 Lysholm
All Rights Reserved, Intl. Copr. Secured
28
Fig 3K
Fig 3L
G. Locate the previously removed coil pack
assembly and modify as follows:
1. Unclip the wiring harness conduit from
the coil bracket. Removing the ignition
coil adjacent to the main plug will aid in
removal. See fig 3J.
2. Locate the supplied coil bracket reloca-
tion heat shield and place on coil bracket
as shown.
3. Transfer the three (3) holes from the
relocation heat shield onto the coil brack-
et. See fig 3K.
4. Using a 5/16” drill bit, drill through the
three (3) marked locations on the coil
bracket. The main connector plug may
need to be removed to avoid damage
during drilling. Remove burrs/sharp
edges. See fig 3L.
Fig 3J
NOTE: Use of a sharp drill and proper lubrication will aid in
drilling through the steel OEM bracket.