Echelon i.LON SmartServer 2.0 Power Line - Manual (Page 139)

i.LON SmartServer 2.0 Power Line Repeating Network Management Guide 125
5. Click Submit. References to the target data points are added underneath the source data point in
the local SmartServer tree on the left frame.
Testing Web Connections
To test that your Web connections are updating the target data points when the value of the source data
changes, follow these steps:
1. Click View and then click Data Points. The View – Data Points Web page opens.
2. Close the graph by clicking the ‘X’ in the upper right-hand corner of the application frame.
3. In the local SmartServer tree, click a source data point.
4. In the remote SmartServer tree (the tree for the SmartServer attached to the power line repeating
network) on the same SmartServer, click the target data points that are bound to the source data
point you selected in step 3. Observe that an IP address property appears on the Web page. This
enables you to distinguish on which SmartServer a data point is located.