Echelon i.LON SmartServer 2.0 Power Line - Manual (Page 36)

22 Installing a Power Line Repeating Network
4. Verify that the Listen on Port property is set to 80. This is the Web services port on the local
Pocket PC device.
5. In the Host property under Resend to LAN, enter the IP address or TCP/IP host name of the
SmartServer.
6. In the Port property under Resend to LAN, enter the port that the SmartServer uses to transmit
and receive HTTP and SOAP messages. The default value is 8080, but you may change it to any
valid port number.
Note: You can click Restore Defaults to return the LAN settings to their defaults.
7. Click Listen. The iLonProxyPocket application now directs all SOAP/HTTP requests generated
by the Street Lighting Helper application on the Pocket PC to the SmartServer.
8. Tap OK.
Sending Device Data to the SmartServer
You can use the Street Lighting Helper application to send the list of devices to the SmartServer.
Upon receiving the list of devices from the Pocket PC, the SmartServer automatically loads,
commissions, and starts the devices. After you send the device data to the SmartServer, you can
remove one to all of the devices from the list.
To send device data from the Pocket PC to the SmartServer, follow these steps:
1. Activate the Street Lighting Helper application. To do this, tap Start, tap Running Programs,
tap Street Lighting in the Running Programs List: box, and then tap Activate. The Street
Lighting Helper application re-opens. The devices you previously entered are listed provided that
the list has not been cleared.
2. Optionally, you can add a previously exported set of devices to the current list. To do this, tap
Program, tap Import, and then tap the .XML file containing the set of devices to be added to the
list or tap the Type list, select Comma Separated (*.csv), and then select a file. The devices
included in the selected file are added to the current list of devices.