Configuring street lighting helper connections – Echelon i.LON SmartServer 2.0 Power Line User Manual
Page 30
16
Installing a Power Line Repeating Network
6. If you are entering the Neuron ID, click Add. The device specified in the Neuron ID box is
added to the device list.
a. If the device being added has the same location or Neuron ID as an existing device, the
Conflict dialog appears. This dialog prompts you to select whether to replace the existing
device, add the new device, or cancel the add operation.
b. Tap Replace Existing to add the new device to the list and remove the existing device; tap
Duplicate Entry to add the new device to the list and keep the existing device there; or tap
Don’t Replace (Cancel) to cancel the add operation and not add the new device to the list.
c. Optionally, you can select the Remember My Decision check box to enable the selected
option to be used automatically for future Neuron ID conflicts.
7. Repeat steps 4–6 for each device to be installed.
8. Optionally, you can save the current list of devices to an XML or CSV file and then send the list to
the SmartServer at a later time. To do this, tap Program, tap Export, enter the file name in the
Name box, select the file type (XML or CSV) from the Type list and then tap Save. The device
list is saved.
9. After you have entered all the devices to be installed, connect the Pocket PC to the SmartServer,
start the iLonProxyPocket application, activate the Street Lighting Helper application, and then
click Send. See the respective sections later in this chapter for more information on completing
these steps.
Configuring Street Lighting Helper Connections
You can use the Street Lighting Helper application to configure the COM ports used for the barcode
scanner and GPS receiver that are connected to the Pocket PC. In addition, you can set the port used
by the Street Lighting Helper application for sending SOAP requests to the SmartServer via
iLonProxyPocket application.
To configure the Street Lighting Helper connections, follow these steps:
1. Tap Program and then tap Connections. The Connections dialog opens.