Echelon i.LON SmartServer 2.0 Power Line - Manual (Page 49)

i.LON SmartServer 2.0 Power Line Repeating Network Management Guide 35
Clear Table Clears all entries in the LON Command Queue table. The table will
automatically re-list pending commands (STATUS_REQUEST) and update
their statuses after the commands successfully complete or fail.
Configure Device Opens the Driver or General properties page for the selected device.
Cancel Command Cancels the selected command and deletes it from the table. You can select
multiple commands by clicking one, holding down CTRL, and clicking the
other commands to cancel. You can also use this option to delete inactive
commands from the table.
Troubleshooting Power Line Repeating Network Installation
If a device is not installed by the SmartServer even after the entire network installation has been
completed, it is likely that the device has failed or the SmartServer cannot reach it through a repeating
device. In this case, you can do the following:
1. Add another device at an intermediate spot on the network that will serve only as a repeater. See
Adding Devices in Chapter 3 for more information on adding devices to an installed power line
repeating network.
2. Replace the device to determine if it has failed. See Replacing Devices in Chapter 3 for more
information on replacing devices on a power line repeating network.