The flash tab, The flash tab –9, Read –9 – Altera Stratix IV E FPGA User Manual
Page 35: Read
Chapter 6: Board Test System
6–9
Using the Board Test System
June 2011
Altera Corporation
Stratix IV E FPGA Development Kit User Guide
The Flash Tab
The Flash tab allows you to read and write flash memory on your board.
Figure 6–4
shows the Flash tab.
The following sections describe the controls on the Flash tab.
Read
The Read control reads the flash memory on your board. Type a starting address in
the text box and click Read. Values starting at the specified address appear in the
table. The base address of flash memory in this Nios II-based BTS design is
0x0800.0000. The valid address range within the 64-MB flash memory is 0x0000.0000
through 0x03FF.FFFF, as shown in the GUI.
1
If you enter an address outside of the flash memory address space, a warning
message identifies the valid flash memory address range.
Figure 6–4. The Flash Tab