BINDER BD 23 - Manual (Page 29)

BD / ED / FD (E2) 02/2015 page 29/63
6.4 User level settings
By pressing down button in normal display (actual value display) for 5 sec, you enter the user menu.
Settings in this menu affect controller operation.
User level overview:
Press down button for approx. 5 seconds
Select the temperature unit (chap. 6.4.1)
Press button
Ramp function (chap. 6.4.2)
Press button
Setting the unit address (chap. 6.4.3)
Figure 6: Press down button for approx. 5
seconds
Press button to return to normal display with display of the temperature set-point. Or:
After approx. 30 seconds the controller automatically returns to normal display / actual value display.
All settings can be carried out independently (as described in he individuel sections) or one after the other
during one single process.
The defined parameters are not deleted when the main power switch is turned off or in case
of power failure.
6.4.1 Temperature unit change between degrees Celsius °C and degrees Fahrenheit °F
If required, the temperature display can be changed as follows:
1. Press down button for approx. 5 seconds.
The display alternately shows “ unit” and the actual setting of the temperature unit:
2. Use the buttons to set the required unit.
3. The set unit is automatically adopted after 2 seconds.
C = degrees Celsius
F= degrees Fahrenheit 0 °C = 31 °F
100 °C = 212 °F Conversion:
[Value in °F] = [Value in °C] ∗ 1.8 + 32
When specifying the set point ramp (see chap. 6.4.2) this setting is accordingly taken as the basis.
If the unit is changed, the temperature set-point and limits are converted accordingly.