CIRCUTOR DHB Series - Manual (Page 45)

45
Bit 15 Not used
Bit 14 Not used
Meter status. Describes the current state of the
meter. Successive bits present the given event. The
bit set on 1 means, that the event took place. Events
can be only erased.
Bit 13 Not used
Bit 12 Not used
Bit 11 Not used
Bit 10 Not used
Bit 9 Status of the RESET input
Bit 8 Status of the START / STOP input.
Bit 7 LED4 – Signaling of alarm No. 4.
Bit 6 LED3 – Signaling of alarm No. 3.
Bit 5 LED2 – Signaling of alarm No. 2.
Bit 4 LED1 – Signaling of alarm No. 1.
Bit 3 Status of the alarm relay 4.
Bit 2 Status of the alarm relay 3.
Bit 1 Status of the alarm relay 2.
Bit 0 Status of the alarm relay 1.
4049 Status2 w/r
Bit 14 RTC clock. Loss of settings
Bit 13 Not used
Bit 12 Lack of communication with data memory
Bit 11 Wrong settings
Bit 10 Manufacturer’ s settings restored
Bit 9 Lack of measured values in data
memory
Bit 8
Reset of the auxiliary counter
Bit 7 Output plate is detected
Bit 6 Output plate – error or lack of calibration
Bit 5 Reset of the main counter (the counter
has been automatically erased)
Bit 4 Not used
Bit 3 Wrong configuration of the individual
characteristic.
Bit 2
Not used
Bit 1 Not used
Bit 0 The averaging period Has not elapsed