CIRCUTOR DHB Series - Manual (Page 50)

50
7. ERROR CODES
After switching the meter on or during the work, messages about errors
can appear.
Messages about errors and their reasons are presented below.
Error message Description
Overflow of upper value of the measuring range value or
the programmed indication range
Overflow of lower value of the measuring range value or
the programmed indication range
ErFrt
Communication error with the data memory. One must
contact the service workshop.
ErPar
Parameter error. Wrong configuration data.
Manufacturer’s settings will be restored after pressing any
button.
ErdEF
Default settings have been restored. One must press any
push-button to transit to a normal work.
ErFPL
Error of measured values stored by the meter (measured
value, maximal value, minimal value). One must press any
push-button to transit to the normal work. After pressing
the push-button, the ErdEF message will be displayed
during one second.
ErCAo
Error of analog output calibration. One must press any
push-button to transit to the normal mode. Analog outputs
will not be serviced. One must contact the Service
Department.
Table 14