CIRCUTOR DHB Series - Manual (Page 49)

49
The value placed In two suc
-
cessive 16-bit registers. These registers include the same data as 32-bit registers from the area 7500 The value is placed in 32-bit registers
Name
Write
(w)
/readout
(r)
Unit Name of the quantity
7000 7500 Identifier 0 —
Constant identifying the device.
The value 181 means the DHB-1xx
meter
7002 7501 Status 0 —
Status is register describing the
current state of the meter
7004 7502 Control 0 %
It is a register defining the steering
out of the analog output
7006 7503 Minimum 0 —
Minimal value of the currently
displayed value
7008 7504 Maximum 0 —
Maximal value of the currently
displayed value
7010 7505
Displayed
value
0 — Currently displayed value
7012 7506
Measured
value on the
auxiliary input
0 —
Currently measured value on the
auxiliary input
7014 7507
Number of
pulses counted
by the Cnt1
counter
0 —
Number of pulses counted by the
Cnt1 counter without additional
calculations
7016 7508
Number of
pulses counted
by the Cnt2
counter
0 —
Number of pulses counted by the
Cnt2 counter without additional
calculations
7018 7509 Status2 0 —
Status2 is register for current status of
the meter (value as in register 4049)
6.6. Registers only for Readout
Table 13