Setting the switches, Figure 2-12. com mode selection switches – Adept AnyFeeder User Manual
Page 29
Installing Cables and Power
Adept AnyFeeder User’s Guide, Rev. B
29
Setting the Switches
The Adept AnyFeeder will be set for serial communications. The Com Mode Selection
switches (see
) must be set as follows:
1. Move the A switch (selects Parallel I/O or RS232) to the down position, to select
Serial.
Figure 2-12. Com Mode Selection Switches
After changing the switch settings, you must cycle power to the Adept AnyFeeder.
• If the Adept AnyFeeder and connected equipment are powered from a common
source, you can turn that source off and then back on.
• If the Adept AnyFeeder and connected equipment are powered from different
sources, then you must disconnect and then reconnect the following cables:
• 24 VDC power cable. See
“Connecting the Power Cable” on page 28
for
details
• Digital I/O interface cable. See
“Digital I/O Cable Installation” on page 27
for details