Adept AnyFeeder - Manual (Page 41)

Serial Command Codes
Adept AnyFeeder User’s Guide, Rev. B 41
Flip Drive has a Servo Problem
Table 3-13 shows responses to the Flip command when the flip drive has a servo problem
( x=5<cr> ).
Unknown Command
Table 3-14 shows responses to an unknown command ( x=9<cr> ).
m16<cr> Drive 1 reports that it is not initialized
Table 3-13: Flip Drive has a Servo Problem
Terminal
Window
Explanation
m21<cr> Drive 2 reports that it is not initialized
m11<cr> Drive 1 reports that it is not initialized
m20<cr> Drive 2 reports end of motion
m13<cr> Drive 1 reports a servo error
Table 3-14: Unknown Command
Terminal
Window
Explanation
m22<cr> Drive 2 reports that this is an unknown command
m12<cr> Drive 1 reports that this is an unknown command
Table 3-12: AnyFeeder not Initialized
Terminal
Window
Explanation