3 removing and installing the feed surface, Figure 5-1. feed deck and drive block – Adept AnyFeeder User Manual
Page 50
Chapter 5 - Maintenance
50
Adept AnyFeeder User’s Guide, Rev. B
NOTE: Maintenance intervals may require adjustment based on
environment and/or application conditions. If you are feeding dirty parts
or if bulk parts contain debris, you may need to shorten the maintenance
interval in order to maintain optimum performance of the equipment.
5.3
Removing and Installing the Feed Surface
The feed surface is subject to wear during normal system use and will need to be replaced
periodically. To replace the feed surface:
1. Purge all parts from the Adept AnyFeeder.
2. Turn off the power and air supply to the Adept AnyFeeder.
3. Disconnect the I/O cable from the front of the Adept AnyFeeder.
4. Loosen the screws on the side rails.
5. Remove the feed surface by sliding it out of the rear end of the Adept AnyFeeder.
6. After the existing feed surface has been removed, clean all residue from the
exposed feed deck. (See
Figure 5-1. Feed Deck and Drive Block
WARNING:
Follow proper lockout procedures before performing this
service procedure. Failure to do so could result in injury.