Argox PA-20 Programming Guide - Manual (Page 17)

PT-20 Programming Guide 15
SDK Library
SDK Functions list
Function Description
Reader
InitScanner1 Initialize respective scanner port.
Decode Perform barcode decoding.
SleepScanner1 Set scanner module sleep.
HaltScanner1 Stop the scanner port from operating.
TriggerStatus To check the scan key status.
Scanner_Reset Set scanner setting to default.
Scanner_Config_Start To start scanner setting procedure.
Scanner_Config_End To end scanner setting procedure.
Scan_SendCommand Send scanner(CCD) command to change scanner status.
SCAN_SendCommand_Laser Send scanner(Laser) command to change scanner status.
Scan_QueryStatus Query the scanner(CCD) current setting.
SCAN_QueryStatus_Laser Query the scanner(Laser) current setting.
ScannerSetFromFile Set scanner setting by scanner setting file. This file is made
by utility “ScanSetting”.
Scanner_Version Query the scan module version.
Sim_ScanKey_Press To simulator the “Scan” key press or release.
Buzzer
beeper_status To see whether a beeper sequence is under going or not.
off_beeper Terminate beeper sequence.
on_beeper Assign a beeper sequence to instruct beeper action.
SetBuzzerVol Set the buzzer volume.
Calender
DayOfWeek Get the day of the week information.
get_time Get current date and time.
set_time Set new date and time to the calendar chip.
Bluetooth(ForPA-2010 /
PA-2110)
BT_Start Bluetooth module power enable.
BT_Stop Bluetooth module power disable.
BT_Open Bluetooth connect.