Artesyn ViewCheck on ATCA-9405 Installation and Use (November 2014) - Manual (Page 14)

Introduction
ViewCheck on ATCA-9405 Installation and Use (6806800S51F) 14
1.2 ViewCheck Access Methods
This section explains various methods for accessing ViewCheck services on Artesyn blades. You
can access ViewCheck using the following interfaces:
 CLI
 XML
Using these interfaces, you can:
 Initiate a diagnostic test
 Query available diagnostic tests
 Query status of a particular diagnostic test
 Start and stop monitoring
 Stop a diagnostic test
 Generate Hardware inventory.
1.2.1 CLI
Using CLI, you can start, stop, and query kind of primitives at this prompt. The ViewCheck CLI
can be accessed via a console using Secure Shell (SSH).
BSF, a proprietary service of Artesyn, is used to provide the CLI access to ViewCheck service.
BSF binaries are provided along with the ViewCheck binaries.
For more information on BSF RPMs and Installation procedures, refer Installation of ViewCheck
on page 21 .
1.2.2 XML
XML interface supports methods, classes, and event notification mechanism. Using XML, you
can start, stop, query, and configure the parameters related to tests and monitors. XML
interface can be accessed in the same manner as CLI and is provided by BSF.