Artesyn ViewCheck on ATCA-9405 Installation and Use (November 2014) - Manual (Page 21)

Chapter 3
ViewCheck on ATCA-9405 Installation and Use (6806800S51F) 21
Installation of ViewCheck
3.1 Overview
This section explains the ViewCheck release modules and installation procedures to install and
run ViewCheck service on the Artesyn ATCA-9405 blade.
ViewCheck service is released as a set of two distinct images.
 ViewCheck RPM Image
This RPM contains all ViewCheck services. BSF service RPMs are also distributed along with
the ViewCheck RPMs. BSF service RPMs provide access to CLI and XML.
 ViewCheck Service OS image
You can download this image from SWORDS. This contains the ViewCheck OOS image for
PPs.
3.2 ViewCheck RPM Image
The ViewCheck RPM Image functionally comprises Diagnostics Framework, specific test cases,
and test suites. The ViewCheck RPM always uses same OS variant and compile time
environment based on the BBS release of the target blade. For ATCA-9405 Service Processor
(SP) blade, the ViewCheck RPM is created for PNE 4.1 environment.
ViewCheck service RPM consists of:
 Diagnostics Core - Daemon
 Static Test Suite Configuration files for the specific blade
 Start/Stop scripts for Diagnostics Core
Using the following command, you can install the ViewCheck RPM Image:
rpm -iv --nodeps diagnostics-
<RELEASE>_<BUILD>.<DIST>.<OS>.9405sp.rpm
If user wants to move to a newly available ViewCheck and BSF RPMs, the current set of RPMs
should be uninstalled before installing the new RPMs. For more information, see
ViewCheck
RPM Image and BSF Service RPM .