Artesyn ViewCheck on ATCA-9405 Installation and Use (November 2014) - Manual (Page 81)

Commands Execution
ViewCheck on ATCA-9405 Installation and Use (6806800S51F) 81
4.6.4 OS
 MemSepTest (SP & PP): Ensures that user space programs cannot read and write to areas
of memory utilized by items such as Video RAM and kernel code.
 SupervisorInstrTest (SP): Ensures that the enforcement of the property that privileged
instructions should only be in supervisor mode is still in effect. The set of privileged
instructions tested to confirm this is architecture dependent.
 DmesgCheckTest (SP & PP): Checks for user-given keywords in the kernel dmesg logs.
4.6.5 PCI
 PCIScanTest (SP): Enumerates all active PCI devices in the blade and ensures board default
configuration is active. This test need to be executed under supervisory mode.
4.6.6 IPMC
 IPMITest (SP): Executes basic IPMI commands and ensures the basic IPMI controller, IPMI
bus functionalities are working properly by reading the response back.
 IPMCSENSOREVENTTest (SP): Verifies IPMC Event generation.
4.6.7 NETWORK
 EthLinkTest (SP & PP): Verifies Ethernet device (for example: eth0, eth1, eth2, etc...) link
status (active/inactive) and also captures various statistics of Ethernet device.
 FloodPingTest (SP & PP): Uses the ICMP protocol’s mandatory ECHO_REQUEST
datagram to elicit an ICMP_ECHO_RESPONSE from a host or gateway.
 EthStatsTest (SP): Tests basic network packet consistency, that is, checks network Rx, Tx
errors, generates a warning if errors are less than or equal to 100 and marks the test as fail
if number of errors are more than 100.
 NetworkCntlrTest (SP): Verifies random data transmitted and also the data received for
each configured network device. It verifies only Ethernet and token ring devices that are
configured and active. The asynchronous devices are not verified.
 SfpDetectionTest(SP): Enumerates all SFP modules connected to SFP ports of blade and
their operational speeds.