Artesyn ViewCheck on ATCA-9405 Installation and Use (November 2014) - Manual (Page 31)

Installation of ViewCheck
ViewCheck on ATCA-9405 Installation and Use (6806800S51F) 31
telnet localhost 15550
Trying 127.0.0.1...
Connected to localhost.localdomain (127.0.0.1).
Escape character is '^]'.
3.6.1 Authenticate
After a connection with XML Agent is established, the only command should be executed is
Authenticate
. This command is for evaluating user credentials.
The Authenticate command contains user name and password for verification. Successful
authentication is signified by the success response, otherwise an error message is returned.
You need to enter the user credentials to XML Agent using the command Authenticate. The
XML Agent forwards the authentication request to the BSF system, which validates the user
credentials and allows the XML client to access it.
 Request:
In the below request, the user credentials “Admin” and "Admin” are created by default in
the BSF. But you need to provide credentials by creating them using the "CreateObject"
command as shown in the section
GetClassList .
<Script><Authenticate><User>Admin</User><Password>Admin</Passwo
rd></Authenticate></Script>]]>]]>
 Response:
The below response is received if the authentication is successful.
<?xml version="1.0"?><Response><Success/></Response>]]>]]>
The following response is received if authentication fails.
<?xml
version="1.0"?><Response><Error><ErrorCode>1</ErrorCode><Type>O
peration not allowed</Type><Description>Authentication
error</Description><CustomError/></Error></Response>]]>]]>
3.6.2 Configure
This command configures the XML protocol for the indentation and the events to
enable/disable state. There are two configuration options available: