Artesyn ViewCheck on ATCA-9405 Installation and Use (November 2014) - Manual (Page 77)

Commands Execution
ViewCheck on ATCA-9405 Installation and Use (6806800S51F) 77
4.5 InService Monitoring Specifics
The In Service Monitoring of ViewCheck provides functionality to:
 Monitor Hardware Device Status
 Monitor Device Critical Errors
Note: Currently monitors are supported only on Service Processor.
4.5.1 Monitoring Hardware Device Status
InService Monitoring also periodically polls for various devices status on the blade. They are
 Storage Device HDD Health Status
 Network Devices Counter Statistics
 Network Devices Error Statistics
Each of the above is identified by a unique Monitor ID. For more information about Monitor ID,
refer
Monitor ID on page 18 .
The default Poll Interval for monitoring each of the Monitor ID is set to 10 seconds. Commands
are provided to edit the default settings.
For more information on the commands provided for InService Monitoring, refer Monitoring
Commands on page 67 .
The following table provides list of monitor IDs and device instances for each of the monitors
being monitored on ATCA-9405.
Table 4-24 Monitors
Monitor Description
Monitor
ID
Valid Device Instances Remarks
HDD Health Status 1010 sda1 and sda2 Monitors the health status of the
sda1 to sda2 partitions on the
HDD and reports.