Avalon Firestyles Cypress - Manual (Page 30)

30
Operation
© Travis Industries 4121130 100-01311
Starting the Stove for the First Time
 Burn the heater at a high setting with the blower off for an extended period (up to 48 hours). This will
cure the painted surfaces. Fumes from the paint curing and oil burning off the steel will occur. This
is normal. We recommend opening a window to vent the room.
 Condensation may appear on the glass each time you start the stove - this is normal.
 Blue Flames will occur on the stove when it first comes on. After fifteen minutes the flames will turn
a more realistic yellow and orange color.
 Certain installations use a remote, thermostat, or wall switch to turn the stove on and off. If this is the
case, leave the ON/OFF switch "ON".
 Verify the power backup and control light batteries are installed (see page 33).
Turning the Stove On and Off
Use the main burner switch to turn the main burner on and off.
NOTE FOR REMOTES, THERMOSTATS, OR WALL SWITCHES:
The on/off switch on the stove may be required to be left in the ON or OFF position for the stove to
operate. Consult your installer or dealer for details.
 Do not place any combustible items on top of or directly in front of the stove, even temporarily.
An optional thermostat may start the stove causing a combustible item to ignite.
 If the stove turns on and off frequently while using a standard thermostat, you may want to adjust
the flame height down until it produces just enough heat needed.
Comfort Control
The rear portion of the burner may be shut off to
lower the heat output and flame size from the
burner (this is called the comfort control). Use the
comfort control switch to adjust this as desired.
Adjusting the Flame Height
This stove has an adjustable flame to tailor the look
and heat output to your specific needs. It is
adjusted by turning the flame adjust knob.
MAIN
BURNER
ON
OFF
COMFORT
CONTROL
HIGH
LOW
FLAME ADJUST