Avalon Firestyles Cypress - Manual (Page 34)

34
Maintenance
(for qualified service personnel only)
© Travis Industries 4121130 100-01311
Accent Light Replacement
An accent light is included in your stove to provide additional lighting. To replace the bulb, follow the directions
below:

Disconnect stove from power. Shut off gas to the stove. Make sure the stove is cool before proceeding (15
minutes).

Remove the stove top and place it aside (see page 26).

Remove the four screws securing the accent light cover. Place the cover to aside.

Remove the two screws securing the accent light assembly. Place the assembly upside down on the firebox top,
making sure the wiring is not damaged or dislodged. When replacing, make sure the glass is aligned below the
assembly.

Loosen the two set screws nearest the bulb to disengage the bulb from the holder. Remove the bulb from the
holder. Replace the bulb, making sure not to touch the bulb with your fingers (grasp the bulb with the bulb
packaging or a paper towel). Tighten the screws until the bulb is secure (do not over-tighten, this may damage
the electrical contacts on the bulb). When the bulb is inserted into the socket the two posts will be exposed
approximately ¼” (6mm) – this is normal.
35 Watt 120 Volt T4 Halogen Bulb (G6.35 Base)
Micro (1/16") Standard
or Philips Screwdriver
Do not loosen these screws
(they hold the wires in place).