Avalon Firestyles Cypress - Manual (Page 43)

Optional Equipment
(for qualified installers only)
43
© Travis Industries 4121130 100-01311
Before replacing the burner, check the instructions for the type of media you are using (log,
stone, or driftwood). Depending upon media type, you may be required to modify the stove.
8
Replace the burner, making sure it is correctly seated. Replace the ember trays.
9
Replace the regulator following the instructions included with the regulator kit. Remove and discard
the screws (see “a” below) holding the stock regulator in place (see “b” below). Remove the stock
regulator and gasket (see “c” below). Place the LP regulator in place, making sure the pre-fitted
gasket (see ”c” below) is in place.
NOTE: There is a label on the base of the regulator knob indicating regulator type (NG or LP).
Secure the regulator with the screws included with the regulator – tighten to 25 lb-in of torque. Place
the included label on the valve body where it can be easily seen to insure proper identification (“d”).
NOTE: Leak test this area after the heater is installed, gas is connected, and the main burner
is lit.
10 Restore the appliance to the correct configuration. Make the gas line connection, bleed the gas line
(if applicable), start the heater and thoroughly leak-test all gas connections and the gas control valve.
a
T-20 Torx or
Slotted Screwdriver
b
c
d