Avalon Firestyles 864 HO GS2 Installation - Manual (Page 28)

28 Installation
(for qualified installers only)
© Travis Industries 4140922 100-01410
Optional Faceplates – Sizing Chart
Name Height Width Notes
FPX Faces 35-3/4” (908mm) 41” (1041mm) Arch Faces have a 45-3/4” (1162mm) Radius – May fit
over top of tile facing
Avalon Faces 34-1/8” (867mm) 36-7/8” (937mm) Optional facing will butt to edge of faceplate (tile line)
Lopi Faces 35-3/4” (908mm) 41” (1041mm) May fit over top of tile facing
Bungalow & Tree of Life Faces 34” (864mm) 36-7/8” (937mm) Optional facing will butt to edge of faceplate (tile line)
Rosario Face 38” (965mm) 42” (1067mm)
Special Instructions for Metropolitan and Victorian Lace Faces
The above faces require the outer grill deflectors to be removed. See the instructions below.
Special Instructions for Wilmington Faces
The above faces require the outer grill deflectors to be removed to allow for installation of the face
mounting brackets. Once the brackets are installed, replace the deflectors. See the instructions below.
Remove the outer deflector on both sides
(use needle-nose pliers if necessary).
These tabs bend down
to allow for removal.
Re-attach the deflectors to the top louver
for future use if using a different face or
grill. Bend the tabs as shown, making
sure the deflectors are secure and flat.
Remove the outer deflector on both sides
(use needle-nose pliers if necessary).
These tabs bend down
to allow for removal.
Re-attach the deflectors once the
mounting brackets are in place. Bend the
tabs down, making sure the deflectors are
secure and flat.