Avalon Firestyles 864 HO GS2 Installation - Manual (Page 44)

44 Installation
(for qualified installers only)
© Travis Industries 4140922 100-01410
5. Install the LP pilot orifice following the instructions below.
(a) Use a 7/16” open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then replace
the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
6. Unscrew the four screws holding the control cover in place. Carefully remove the control cover.