Avalon Firestyles AGP - Manual (Page 22)

22
Operation
© Travis Industries 4141230 100-01270
Loading Pellets
Lift the hopper lid to its vertical position. Pour pellets into the hopper.
NOTE: If the hopper lid is opened for more than 1 minute, the stove will enter shut down cycle. If
this happens, simply restart the stove.
WARNING: The stove top becomes hot during operation. Make sure to keep any flammable items
(bag of pellets) away from the top while reloading.
NOTE: The stove will not run if the lid is open.
Starting the Heater for the First Time
Start the Heater - Let it Burn for 1 Hour - THEN OPEN THE DOOR.
The stove paint is cured through heat. To prevent it from bonding to the door gasket, you must burn
the heater for approximately 1 hour, then open and close the door to break any bonding.
Curing the Paint
This stove uses a heat-activated paint that will
emit some fumes while starting the first fire.
Open doors and windows to the room to vent
these fumes. You may also notice oil burning
off of the interior of the stove. This rust-
stopping agent will soon dissipate. Allow 48
hours for the paint to cure.
2 to 4 hours
Allow 48 hours