Avalon Firestyles AGP - Manual (Page 44)

44
Optional Equipment
© Travis Industries 4141230 100-01270
Thermostat Installation (Optional)
DO NOT CONNECT 120 VAC OR 24V TO THE THERMOSTAT CIRCUIT OF THIS HEATER
(DO NOT USE A HOUSEHOLD THERMOSTAT USED FOR A WALL-BOARD OR OTHER
ELECTRICAL HEATER). USE A LOW VOLTAGE COMPATIBLE THERMOSTAT.
Wired (99300650) or wireless thermostats (99300689) may be attached to this appliance. Open the left
side access panel and locate the wires labeled “TSTAT”. Route the thermostat wires to this location and
attach them to these wires (orientation does not matter). Make sure the wires do not contact hot or
moving components. See the instructions included with the thermostat for further details.
Outside Air Kit
See the instructions included with the outside air kit for full details.
3/8" Screws
Cover Plate &
1-1/4" screws
1-1/4"
Screws
1-3/4" Diameter Flex Duct
Select a location between framing
members for the outside air hole.
Hood with Screen
Cut a minimum 2" diameter hole in the wall
(use 2" dia. hole saw).
Silicone
Seal the area around the
tube to prevent air from
entering through the wall.
Silicone
3-1/2"
Centerline
5-3/4"
Back of AGP Pellet
Stove
Silicone