Avery Dennison Monarch 9860 Operator Handbook - Manual (Page 15)

5. Adjust the supply holder guides so the sides barely touch the
roll. Make sure the supply roll turns freely.
6. Push down on the supply lever to unlock the supply guides.
7. Lay the supply into the feed path. Tuck the supply under the
nibs and in between the die cut sensor. Do not feed supply
between the supply roller and deflector.
8. Feed the supply between the upper and lower knife guides.
Make sure at least 0.5 inches of supply is through the knife.
Supply Holder
Guides
Loading Supplies
2-3