Avery Dennison Monarch 9860 Operator Handbook - Manual (Page 27)

If the brush does not remove all the adhesive
◆ Use isopropyl alcohol ONLY on the standard (black) platen
roller.
Moisten a cotton swab with isopropyl alcohol and run the
cotton swab across the platen roller. Turn the platen roller
with your finger to make sure the platen roller is clean all the
way around.
After cleaning, feed several inches of supply through without
printing to remove any remaining isopropyl alcohol.
◆ call Service to clean the linerless (red/orange textured) platen
roller.
DO NOT use alcohol or solvents on linerless
(red/orange textured) platen rollers.
5. Moisten a cotton swab with isopropyl alcohol. Rub the cotton
swab across the peel bar and remove any build-up.
6. Moisten another cotton swab with isopropyl alcohol. Rub the
cotton swab across the printhead and remove any build-up.
You may need to use a printhead CLEAN-STRIP if the
printhead is extremely dirty or you see streaks on the supply.
Printhead
Care and Maintenance
4-3