Avery Dennison Monarch 9860 Operator Handbook - Manual (Page 50)

To change the setting, from the Main Menu, select Setup, Supply,
then Positioning. Then, follow these steps.
1. Press l or r until you see
POSITIONING
l
Margin Pos
r
2. Press N. The current setting is displayed, for example:
Enter margin pos
[-99/99]: +0
3. Press l or r to change the margin position. Pressing l
decreases the value (moves the image toward the left side of
the supply);
r increases it (moves the image toward the right
side of the supply).
4. Press N when the number you need appears. Press E
until you see the Main Menu.
C u t P o s i t i o n
This function adjusts where the tag is cut. The printer adjusts the
cut position according to the black marks on the supply. You may
need to adjust for aperature supplies. Increase to move the cut
up; decrease to move the cut down.
To change the setting, from the Main Menu, select Setup, Supply,
then Positioning. Then, follow these steps.
1. Press l or r until you see
POSITIONING
l
Cut Pos
r
6-12 Setting Supply Options