Baby Lock EmbroideryPro_BMP8_InstructionRef (BMP8) Instruction and Reference Guide - Manual (Page 110)

Setting the Machine to Stop at Color Changes 93
4
3
Touch so that it changes to .
X The mark appears to indicate where the
machine will stop.
1 mark
4
Repeat steps
2
and
3
for each pause that
you wish to specify.
• Any number of pauses can be specified.
5
After specifying the desired settings, touch
.
X The screen that was displayed before
was touched appears.
• If the machine is temporarily turned off
when it is stopped at the specified location
after embroidering, you will be asked if you
wish to continue sewing or select a new
pattern when the machine is turned on
again.
Touch to continue embroidering.
(Refer to “Resume Embroidering After
Turning OFF the Machine” on page 83.)
Memo
● If the machine is temporarily turned off, the
settings to stop the machine at color
changes specified before the machine was
turned off are not cancelled. However, the
settings are cancelled if a new pattern is
selected.
● If a pattern with the settings to stop the
machine at color changes is saved, the
settings to stop the machine at color
changes are also saved.