Baby Lock EmbroideryPro_BMP8_InstructionRef (BMP8) Instruction and Reference Guide - Manual (Page 134)

Selecting an Embroidery Pattern 117
5
■ Disconnecting the USB cable
Before disconnecting the USB cable, click the
“Unplug or Eject Hardware” icon in the taskbar of
Windows
®
Me/2000 or the “Safely Remove
Hardware” icon in the taskbar of Windows
®
XP.
Then, when the removable disk has been
removed safely, disconnect the USB cable from
the computer and the machine.
With Windows 98SE, check that the Access lamp
is not flashing before disconnecting the USB cable
from the computer and the machine.
Note
● Be sure to perform the operation described
above before disconnecting the USB cable
from the computer and embroidery
machine, otherwise the computer may
malfunction, the data may not be written
correctly, or the data or data writing area on
the embroidery machine may be damaged.
USB media
(Commercially Available)
You can recall a specific embroidery pattern from
either directly USB media or a folder in the USB
media. If the embroidery pattern is under the folder,
move down layers of folders following a path to it.
For details on storing a pattern, refer to “Saving
Embroidery Patterns” on page 137.
Note
● USB media and reader/writer units can be
purchased at electronic/computer retailers.
● Some USB media may not be usable with
this machine. Please visit our web site for
more details.
1
Insert the USB media into the machine’s USB
Type “A” (host) port.
Depending on the type of USB media being
used, either directly plug the USB device into
the machine’s USB port on the right side of the
operation panel or plug the USB Card Reader/
Writer into the machine’s USB Type “A” (host)
port.
When connecting the USB Card Reader/Writer
to the machine’s USB Type “A” (host) port, be
sure to secure the cable with the three hooks
on the back panel. If the cable is not secured,
the embroidery frame may catch on the cable
while the frame is moving, causing the pattern
to become misaligned.