Baby Lock EmbroideryPro_BMP8_InstructionRef (BMP8) Instruction and Reference Guide - Manual (Page 143)

SELECTING/EDITING/SAVING PATTERNS ————————————————————————————————————————
126
■ Trimming the threads between characters
If the machine is set to trim the threads between
the characters, the jumpstitches between the
characters are reduced and any other necessary
procedures after embroidering are reduced.
However, the embroidering time will increase if
the threads are trimmed between each of the
characters.
3
If necessary, specify that the threads be
trimmed between characters.
Touch so that it changes to .
• Each touch of the key turns the setting either
on or off.
4
If necessary, touch the arrow keys to adjust
the position of the pattern.
For more details, refer to page 121.
5
After making the desired changes, touch
.
X The pattern editing screen appears again.
Changing the thread density
(only for some character and frame patterns)
The thread density for some character and frame
patterns can be changed.
A setting between 80% and 120% in 5% increments
can be specified.
1
Touch .
X The screen shown below appears.
1 Selects a less thread density
2 Selects a more thread density
3 Touch this key to close this screen.
■ Selects a less thread density
Less Standard More
■ Selects a more thread density
Less Standard More
Threads are not
trimmed.
Threads are
trimmed.