Baby Lock EmbroideryPro_BMP8_InstructionRef (BMP8) Instruction and Reference Guide - Manual (Page 90)

Changing the Embroidering Position 73
3
2
Touch the arrow keys in the embroidery
settings screen to move the embroidery frame
so that the needle drop point is at the center
of the area where you wish to embroider.
• When specifying the starting of stitching,
align the needle drop point with the point
specified as the starting of stitching. (For
details on specifying the starting/ending of
stitching, refer to page 89.)
■ Unlocking the needle bar
1
Display the embroidering screen, and then
touch the key for any needle bar other than
the one that is locked.
X The needle bar is unlocked.
Adjusting the angle
Depending on the type of fabric being embroidered,
it may not be possible to stretch the fabric in the
embroidery frame at the desired angle. In this case,
adjust the angle of the pattern so that it is correctly
positioned on the fabric.
1
Touch .
The screen shown below appears.
Example: Original angle
1 Rotates 90 degrees to the left
2 Rotates 10 degrees to the left
3 Rotates 1 degree to the left
4 Rotates 90 degrees to the right
5 Rotates 10 degrees to the right
6 Rotates 1 degree to the right
7 Touch this key to return the pattern to its original
angle.
8 Moves the pattern in the direction of the arrow on
the key.
9 Enables the embroidering area to be
checked
0 Touch this key to close this screen.