Baby Lock EmbroideryPro_BMP8_InstructionRef (BMP8) Instruction and Reference Guide - Manual (Page 35)

EMBROIDERING TUTORIAL ——————————————————————————————————————————————
18
1. Installing the Bobbin
When the machine is purchased, only the bobbin case is installed in the hook. Insert a bobbin wound with
bobbin thread for embroidering. For precautions concerning the bobbin, refer to page 15.
Note
● The machine cannot indicate how much
bobbin thread is remaining. Before starting
to embroider make sure that there is enough
bobbin thread for the pattern.
● Make sure to clean the bobbin case every
time the bobbin is changed. For details on
cleaning the bobbin case, refer to “Cleaning
the bobbin case” on page 197.
Removing the bobbin case
1
Open the hook cover.
Pull the hook cover toward you.
2
Pull the thread picker toward you.
1 Thread Picker
To gain access to the bobbin case easily, pull
the thread picker toward front.
Note
● Thread picker is a device that is used to
hold the thread when begining to sew or
when trimming the thread.
3
Grab the bobbin case latch, and remove the
bobbin case.
1 Latch
■ Oiling the machine
After removing the bobbin case, apply oil to the
machine. The race should be oiled. For details on
oiling the machine, refer to “Oiling the machine”
on page 198.
Note
● Put a drop of oil onto the hook once a day
before use.
● The thread picker can only be moved
within a certain range. Do not pull it with
extreme force.
1
CAUTION
1