Baby Lock EmbroideryPro_BMP8_InstructionRef (BMP8) Instruction and Reference Guide - Manual (Page 24)

Setting Up the Machine 7
1
Setup location
Setup the machine in a location that meets the following requirements.
• Position machine more than 50 mm (2 inches) from the wall
• Allow sufficient space around the machine
• Place no objects within the moving range of the embroidery frame
• Set-up machine near an electrical outlet
• Use a level and stable surface, such as a desk
• Use a surface that can support the weight of the machine (about 37 kg (81 Ibs.))
• Allow open space around the ventilation slots at the bottom toward the back
Note
● For your safety: Since the machine weighs approximately 37 kg (81 lb.), do not set it up on an unstable
table or desk.
● In order to prevent malfunctions or damage, do not set up the machine in a location exposed
to the following conditions.
More than
50 mm
(2 inches)
More than
350 mm
(13-3/4 inches)
More than
250 mm
(9-7/8 inches) 512 mm
(20-5/32 inches) More than
250 mm
(9-7/8 inches)
770 mm
(30-5/16 inches)
589 mm
(23-3/16 inches)
CAUTION
Direct sunlight
Extreme dust
Insufficient space
An unstable surface
Connection to extension
cords or multiple
adapters
Extremely high or extremely low temperatures (The operating
environment should be between 5 °C (40 °F) and 40 °C (104°F)
Liquids, such as water
Blocked ventilation
slots
Objects within the
moving range of the
embroidery frame