BAFO BF-8000 - Manual (Page 19)

19
Chapter 4
Setup Diagnostics
4.1 Hardware Diagram
The Bluetooth USB Dongle is plug-and-play. During the software installation process, you will
be prompted to plug in the USB dongle to an available USB port. When you plug in the USB
Dongle to the USB port, the green Rx LED and the red Tx LED on the USB dongle should light
up. See the diagram below. The Bluetooth Dongle LEDs illuminate during connection or data
transfer to indicate that the dongle is functioning. Refer to the following table.
Status
LED
Receiving Transmitting Ready
Rx Indicator Green (quick flash) Solid Green Solid Green
Tx Indicator Solid Red Red (quick flash) Red (blinking)
4.2 Verifying Hardware and Software Installation
Once you have the Bluetooth software installed and plug in the Bluetooth USB dongle, the
Bluetooth icon will be displayed on the system tray. To check that the wireless Bluetooth
USB dongle drivers and software are loaded properly:
Right-click on the Bluetooth icon on the system tray and select “Advanced
Configuration” from the shortcut menu.
Rx Indicator
Tx Indicator