Introduction – Basler Electric BE1-50/51M User Manual
Page 3
9252000990 Rev R
BE1-50/51M Introduction
i
INTRODUCTION
This instruction manual provides information about the operation and installation of the BE1-50/51M
Overcurrent Relay. To accomplish this, the following information is provided:
General Information and Specifications
Controls and Indicators
Functional Description
Installation and Maintenance
Testing
WARNING!
To avoid personal injury or equipment damage, only qualified personnel should
perform the procedures in this manual.
NOTE
Be sure that the relay is hard-wired to earth ground with no smaller than 12
AWG copper wire attached to the ground terminal on the rear of the unit case.
When the relay is configured in a system with other devices, it is
recommended to use a separate lead to the ground bus from each unit.