Becker TRAFFIC ASSIST 7926 - Manual (Page 25)

25
>>>
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> SK
Adjusting the unit bracket
The support plate (7) can be swung in two
directions (horizontally and vertically). It
can thereby be set at virtually every angle
of vision to the driver.
Vertical movements
> Loosen the fastening screws (2) on both
sides far enough to be able to swivel the
carrier plate (7) downwards from above
without exerting excessive force.
> Use one hand to hold the foot (5) and
swing the support plate (7) up to the
centre or down into the position you
want.
> Tighten the fastening screws (2) suffi-
ciently so that the Traffic Assist is held
securely in place when the vehicle is in
motion.
Horizontal movements
> Loosen the locking screw (1) until the
support plate (7) can be swung from left
to right without too much effort.
> Use one hand to hold the foot (5)
and swing the support plate (7) to the
left, to the centre or to the right into the
position you want.
> Retighten the locking screw (1) again so
that the Traffic Assist is secure for trav-
el.
Adding the Traffic Assist
The unit holder (6) is equipped with four
guides, the carrier plate (7) has corre-
sponding retaining lugs.
> Position the unit holder with the guides
onto the carrier plate retaining lugs.
> Slide the unit holder downwards to the
stop.
The Traffic Assist has receptacles for the
unit holder on the top and bottom of the
housing.
> Insert the Traffic Assist into the unit
holder with the receptacles on the bot-
tom of the housing.
> Press the Traffic Assist into the unit
holder without employing excessive
force until the clip (8) engages in the re-
ceptacle.
Note:
Do not swing the support plate in both
directions at the same time! Before mov-
ing, always take the Traffic Assist off the
unit bracket.
Note:
To remove the Traffic Assist, press the
clip (8) on the unit holder with one finger
and remove the unit from the unit holder
using your free hand.