BECKHOFF CX1100-000x - Manual (Page 47)

Fitting and wiring
Embedded PC 45
Do not force the module or apply
excessive pressure!
Only apply pressure at insensitive points of the housing (edges). Never apply pressure on the display, the buttons or
movable parts of the CX10x0 system. After successful latching on the DIN rail the straps should be pushed back to
their original position.
At least the power connections must be installed. The upper connections "24v" and "0V" must be connected to power
supply. If the power supply CX1100-0001 is used the power supply is connected via the 5-pin open style connector.
(see connections / wiring)