Cadac M16 - Manual (Page 36)

4-12
M16 Microphone Amplifier Revision MA2005-7
switch will illuminate. To cancel Phantom Power, simply press the
48v switch again.
NOTE: Phantom Power provides up to 14mA load current per
microphone.
NOTE: Good operating practice is to Mute a particular channel
before enabling or disabling Phantom Power. This prevents the
potential for any audio thumps occurring.
4.18 High Pass Filter:
To enable the selected channel’s High Pass Filter to remove any low
frequency rumble, press the High Pass Filter switch. Once enabled,
the switch will illuminate. To deactivate the High Pass Filter, press
the switch again.
GENERAL NOTE: Communication is bi-directional, so it is pos-
sible to alter settings directly on the M16 and the RM16 (if se-
lected to that channel). Any changes made directly to the M16
will be reflected in the RM16. This applies to Gain, Pad, Phase,
Reverse, Phantom Power and High Pass Filter settings.