Caple CM400FA - Manual (Page 10)

• Partially remove the machine from its seat-
ing.
• Take the appliance out very slowly and in
order to guarantee maximum safety, make
sure that no people or things are below it.
• Pull the water tank up and especially the
first time, wash it with soapy water; then
rinse it carefully, taking care to remove all
soap residues.
• Fill the tank with water (this does not apply
to the version connected to the water mains)
• In the same way, open the coffee bean con-
tainer and pour in the coffee without reach-
ing the maximum level; then refit the coffee
container lid.
UK
40
CAUTION
RISK OF POLLUTION
Do not dispose of packaging in the environ-
ment.
Before carrying out any installation and
adjustment operations you must read and
fully understand the SAFETY INSTRUC-
TIONS of this handbook.
The company cannot be held responsible
for damage to things or injury to persons
caused by failure to comply with the safety
instructions and installation and mainte-
nance instructions contained in this hand-
book.
CAUTION
RISK OF SHORT CIRCUITS
Before connecting the machine to the mains
power supply, please check that the supply
voltage corresponds to the machine volt-
age.
4. PRELIMINARY OPERATIONS
4.1 FILLING THE
APPLIANCE
The water hardness must be less than 4° -
6° fr (french degree).
For this reason, where water hardness
exceeds this level, it is advisable to fit a
device to soften it to the recommended
level. For machines with water tank, use
water with a hardness of 4°-6° fr.
The chlorine contents is max 100 mg per
litre (0.00000361 lb/cu in).
Otherwise the conditions of guarantee of
the machine will expire.
CAUTION
WARNING
SCM5
Switch off the machine before filling or
removing the water tank.
SCM5_UK_Rev_2.qxp 23/01/2008 15.58 Pagina 40