Code CR3500 - Manual (Page 14)

C004387_07_CR3500_User_Manual - 8 Save Settings
CR3500 with Cabled Handle - If a handle was purchased for use with the CR3500, the 8-pin DIN connector is at the bottom of the
handle (Figure 1.11). Insert the 8-pin connector and firmly push the cable into the handle. The cable has a locking mechanism that will
firmly hold the cable in place. If using the H2 cabled handle, for additional stability, there is an optional cable attachement clip that can
secure the cable to the handle with two threaded screws (Figure 1.12).
1.8 - Cabled Operation
1.8.1- Introduction
The CR3500 is a Multi-Interface Unit (MIU) and is available with USB and RS232 cables. All of the cables are connected to the CR3500
with a 8-pin DIN connector (Figure 1.8).
Hand Held CR3500 - To install a cable directly to the CR3500, correctly line up the 8-pin DIN connector into the back end of the reader.
The arrows on the connector should be facing down (Figure 1.9). When the reader and the cable connector are lined up, firmly push
the cable into the reader. The cable has a locking mechanism that will firmly hold the cable in place (Figure 1.10). To dettach the cable
from the reader, you must pinch the plastic on the 8-pin DIN and pull back to disengage the connector.
Figure 1.9 Figure 1.10
Figure 1.11
Figure 1.12
Figure 1.8