Code CR3500 - Manual (Page 53)

C004387_07_CR3500_ User_Manual - 47 Save Settings
CR3500 has a battery-powered real time clock embedded in the reader. When enabled, the time stamp will be a prefix to the data.
Time stamping continues until disabled. The time stamp will be shown in the following format: YYYY-MM-DD HH:MM:SS
On Off (Default)
Note: Turning on the time stamp feature will cause the reader to re-start. Make sure previous settings have been saved prior to
scanning the code or you will lose unsaved settings.
4.9 - Time Stamp Settings
This mode can be used to establish a permanent connection between the reader and a CodeXML® modem,
Prepare the reader to communicate in ‘RF Comm Mode’ by scanning the QuickConnect code on the paired modem to which you wish
to establish a permanent link. Listen for the single beep to verify the connection acknowledgement. Scan the Lockout Link Mode code
(see below). Set appropriate timeout settings, if applicable (see Section 1.4.5).
To reassign a permanent connection to a different reader, scan the unlock link code. Using the ‘new’ reader’ follow the directions
outlined in the previous paragraph.
Lockout Link Mode Unlock Link Mode
4.10 - Lock-out Link Mode