DFI HU968 - Manual (Page 13)

www.dfi .com Chapter 3 Hardware Installation
13
Chapter 3
Connectors
CPU Fan Connector
Connect the CPU fan’s cable connector to the CPU fan connector on the board. The cooling fan
will provide adequate airflow throughout the chassis to prevent overheating the CPU and board
components.
BIOS Setting
“Module Board H/W Monitor” submenu in the Advanced menu of the BIOS will display the cur-
rent speed of the cooling fan. Refer to chapter 3 of the manual for more information .
3
1 Sense
+12V
Ground
COM Express Connectors
The COM Express connectors are used to interface the HU968 COM Express board to a carrier
board. Connect the COM Express connectors (located on the solder side of the board) to the
COM Express connectors on the carrier board.
Refer to the “Installing HU968 onto a Carrier Board” section for more information.
Refer to the following pages for the pin functions of these connectors.
COM Express Connectors