DFI KB968 - Manual (Page 26)

www.dfi .com Chapter 3 Hardware Installation
26
Chapter 3
Cooling Option
Heat Sink with Cooling Fan
• “1” and “2” denote the locations of the thermal pads designed to contact
the corresponding components that are on KB968.
Top View of the Heat Sink
Bottom View of the Heat Sink
Important:
Remove the plastic covering from the thermal pads prior to mounting the heat sink
onto KB968.
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
1 2
Standby Power LED
This LED will light when the system is in the standby mode.
Standby
Power LED