Chapter 3 – DFI KB968 User Manual
Page 29
Advertising
www.dfi .com
Chapter 3 Hardware Installation
29
Chapter 3
9. Use the provided mounting screws to secure KB968 with heat sink to the carrier board
and then connect the cooling fan’s cable to the fan connector on KB968. The photo below
shows the locations of the long mounting screws.
Long screws
10. And then connect the cooling fan’s cable to the fan connector on KB968.
Fan connector
8. Verify that the module is firmly seated onto the COM Express connectors of the carrier
board.
The module is completely
seated on the carrier board
KB968
Carrier board
KB968
Advertising