Digi-Star StockWeigh 550 EID - Manual (Page 20)

StockWeigh 550 EID and StockWeigh Link
16
Appendix A
EID Reader
WARNING: The StockWeigh 550 EID connects to Allflex     ISO Compatible RFID Stick
Readers only. Do not attempt to use with other RFID readers or
peripherals that are not approved by Digi-Star.
DAMAGE MAY OCCUR.
CAUTION: The ALLFLEX TM Stick Reader reconfigures the output format if the button is
depressed while powering “ON”. Be careful not to lay the stick reader with the
button down while applying power.
NOTES: The Allflex  Stick Reader gets its power from the StockWeigh EID 550 “EID Reader” port and
does not use an external power cube.
If there is a problem with the Allflex  RFID Stick Reader or the number of characters it is
transmitting, follow the procedure below to re-configure the stick reader to the TIRIS S2000
output format.
Refer to the Allflex  RFID Stick Reader manual for details.
Re-Configuring the Allflex     Stick Reader
1. Turn power off on the StockWeigh 550 EID indicator.
2. Connect the Stick Reader to the EID Reader port.
3. Press and hold the “READ” button on the Stick Reader while pressing the “ON”
button on the indicator.
4. After 2 seconds, the Stick Reader will respond with 6 flashes and 6 beeps. Release
the “READ” button.
5. Press the “ON” button on the Indicator to start the self-test. Wait for the test to finish
and press the “NET/GROSS” key after the prompt to re-configure the Stick Reader
to the TIRIS 2000 output format.
6. If re-configure is successful, indicator will display “GOOD”. If indicator displays
“ERROR”, try procedure again.
.....
Contact Digi-Star Technical Service if problems persist.