Parking brake, Parking brake -34 – Hummer 2006 H2 User Manual

Page 110

Advertising
background image

Shifting Out of NEUTRAL

To shift the transfer case out of NEUTRAL, do
the following:

1. Set the parking brake and apply the regular

brake pedal.

2. Shift the transmission to NEUTRAL (N) and turn the

ignition to RUN with the engine off.

3. Press the button for the desired transfer case shift

position (Four-Wheel High, Four-Wheel-High Lock,
or Four-Wheel-Low Lock).

4. After the transfer case has shifted out of NEUTRAL

the red light will go out.

Notice: Shifting the transmission into gear before
the indicator light stops flashing could cause
damage to the transfer case. Always wait until the
indicator light stops flashing before putting the
transmission back in gear.

5. You may start the engine and shift the transmission

to the desired position.

Parking Brake

To set the parking brake, hold the regular brake pedal
down with your right foot. Push down the parking
brake pedal with your left foot.

A chime will activate and the warning light will flash when
the parking brake is applied and the vehicle is moving at
least 3 mph (5 km/h) for at least three seconds.

To release the parking brake, hold the regular brake
pedal down. Pull the bottom edge of the lever, located
above the parking brake pedal, with the parking
brake symbol, to release the parking brake.

2-34

Advertising