Assist steps, Assist steps -34, After off-road driving – Hummer 2006 H2 User Manual

Page 288

Advertising
background image

After Off-Road Driving

Remove any brush or debris that has collected on the
underbody, chassis, or under the hood. These
accumulations can be a fire hazard.

After operation in mud or sand, have the brake linings
cleaned and checked. These substances can cause
glazing and uneven braking. Check the engine and oil
coolers for mud accumulation. Thoroughly and carefully
clean these devices to allow proper cooling. Check
the body structure, steering, suspension, wheels, tires,
and exhaust system for damage. Also, check the
fuel lines and cooling system for any leakage.

Your vehicle will require more frequent service due to
off-road use. See the Maintenance Schedule for
additional information.

Assist Steps

Your vehicle may be equipped with removable side steps.

Remove the steps prior to off-roading to give your
vehicle more ground clearance and to prevent damage
to the vehicle from the side steps dragging and/or
catching on obstacles.

Notice: Do not drive off-road with the side steps
attached to your vehicle. You can damage the side
steps and/or your vehicle’s frame if they get caught
or drag against an obstacle. This damage would not
be covered by your vehicle’s warranty. Always
remove the side steps prior to any off-road driving.

U-Type Side Steps

The following instructions show how to install the
optional U-type steps. If you want to remove them, just
reverse the instructions:

1. Start with the side step brackets pointing up and

away from you, or just make sure the HUMMER
logo faces up.

2. For the front step, use the first and third brackets

on the vehicle from the front tire. For the rear step,
use the first and third brackets on the vehicle
from the rear tire.

You will notice that the side steps have pins on
both sides of the step brackets. This is because the
steps are interchangeable between front/back
and the driver/passenger sides of the vehicle. Use
the pins as follows:

Driver Side: Look at the side step with the
HUMMER logo facing you. You will use the pins
which are on the right side of each side step
bracket. This works for the front or rear of
the vehicle.

Passenger Side: Look at the side step with the
HUMMER logo facing you. You will use the pins
which are on the left side of each side step
bracket. This works for the front or rear of
the vehicle.

4-34

Advertising