Hummer 2006 H2 - Manual (Page 149)

Windshield Wipers
You control the windshield wipers by turning the band
with the wiper symbol on it.
8 (Mist): For a single wiping cycle, turn the band to
mist. Hold it there until the wipers start. Then let go. The
wipers will stop after one wipe. If you want more
wipes, hold the band on mist longer.
N (Delay): You can set the wiper speed for a long or
short delay between wipes. This can be very useful
in light rain or snow. Turn the band to choose the delay
time. The closer to the top of the lever, the shorter
the delay.
6 (Low Speed): For steady wiping at low speed,
turn the band away from you to the first solid band past
the delay settings.
1 (High Speed): For high-speed wiping, turn the
band further, to the second solid band past the
delay settings.
9 (Off): To stop the wipers, move the band to off.
Be sure to clear ice and snow from the wiper blades
before using them. If they’re frozen to the windshield,
carefully loosen or thaw them. If your blades do become
worn or damaged, get new blades or blade inserts.
Windshield Washer
{ CAUTION:
In freezing weather, do not use your washer
until the windshield is warmed. Otherwise the
washer fluid can form ice on the windshield,
blocking your vision.
LQ (Washer Fluid): There is a paddle marked with
the windshield washer symbol at the top of the
multifunction lever. To spray washer fluid on the
windshield, push the paddle. The wipers will clear the
window and then either stop or return to the preset speed.
_
(Heated Washer Fluid): If your vehicle is equipped
with the heated washer system, approximately
five seconds after turning on your vehicle, it will be in
Standby mode. Heated windshield fluid can spray
for three to six seconds to the windshield when the
washer fluid paddle is used. The heated fluid is
discharged by pushing the normal wash paddle in the
vehicle. Standby mode is activated every time the
vehicle is turned on.
3-9